Under the action of the skeleton oil seal, the rigidity of the oil film just makes the oil film and the air contact end form a crescent surface, which prevents the leakage of the working medium and realizes the sealing of the rotating shaft. The sealing ability of the oil seal depends on the thickness of the oil film on the sealing surface. If the thickness is too large, the oil seal will leak; if the thickness is too small, dry friction may occur, causing the oil seal and shaft to wear; if there is no oil film between the sealing lip and the shaft, it is easy to cause heat and wear. . Therefore, when installing, it is necessary to apply some oil on the sealing ring, and at the same time ensure that the skeleton oil seal is perpendicular to the axis line. If it is not perpendicular, the sealing lip of the oil seal will drain the lubricating oil from the shaft, which will also lead to excessive sealing of the lip. wear. During operation, the lubricant in the casing seeps out a little, so that it is ideal to form an oil film on the sealing surface.
In conclusion, installing oil seals correctly is an important step in maintaining the performance and efficiency of rotating machinery. By following these steps, you can ensure that your oil seals are installed correctly and will provide a leak-free performance. If you have any questions or concerns about installing oil seals, consult with a professional or refer to the manufacturer's instructions. Proper installation of oil seals can help to extend the life of your machinery, reduce the risk of leaks, and ensure a safe and efficient operation.
Lubricants applied between moving and stationary elements of mechanical equipment help to prevent damage. But when the equipment are under high pressure, the lubricants tend to escape, hence the need for oil seals to prevent the clashing of dry parts. Practically all mechanical equipment, including car engines, assembly machines, and PTFE machined parts use these oil seals to prevent harmful interaction that can result in damaged parts.
There is a British Standard laid down for the control of synthetic rubbers. BS 3574 (1989) helps to determine shelf life – for instance, Nitrile (NBR) and Polyacrylic (ACM) are Group ‘B’ rubbers and have a 7-year life, whilst Silicone (VMQ) and Fluoroelastomers (Viton®) are Group ‘C’ rubbers and have a 10-year shelf life. PTFE and Leather do not come into this category but like the others should be kept in the original packing for as long as possible away from direct light, dust, and humidity. Ozone, which can also be produced by battery-driven forklift trucks has a very bad effect on synthetic rubbers. Finally, protect the sealing lip – DO NOT hang the seals on nails, wire etc.