Galvanized hexagonal net is a kind of galvanized metal wire mesh, mesh shape is hexagonal.
Different from double strands of barbed wire to install directly on the ground, the blade thorn rope is fixed on some affiliate products just again, as was the case according to the common on the wall, often wall width is far lower than the diameter of the blade thorn rope under the premise of no such device is fixed in place, use special stents to prevent blade thorn rope can better protect us.
The quantity should be the same as the contract, cold drawing, carefully record the quantity of each specification and packing method. If there is a label, check whether the label is correct and take a photo to confirm. Each roll of iron wire is fastened with galvanized packing tape, and then tied with a very strong transparent plastic bag. The coated iron wire is wrapped with white braided cloth, and the galvanized iron wire is wrapped with green braided cloth, so as to ensure that the packaging will not be lax in the transportation process.
Different from common zinc barbed rope, high zinc barbed rope surface zinc content is very high can reach 6-8 times of the former, so there is a great advantage in the service life, ordinary products begin to corrosion three to five years while the latter will take longer to change. Stainless steel barbed rope is in material protection so durability is also better, these two products are long service life, but in terms of high price.
Therefore, when the zinc reaches saturation in the solid melt, the two elements of zinc and iron atoms are diffused with each other, and the zinc atoms diffused into (or infiltrated into) the iron matrix migrate in the lattice of the matrix and gradually form an alloy with the iron, while the iron diffused into the molten zinc liquid forms an intermetallic compound FeZn13 with the zinc and sinks into the bottom of the hot galvanized pot, that is, zinc slag. When the workpiece is removed from the zinc leaching solution, the surface of the pure zinc layer is formed, which is hexagonal crystal, and its iron content is not more than 0.003%.
Cold galvanized by electrolytic action to metal and other materials surface attached to a layer of metal film, so that the surface of the material uniform texture, anti-corrosion wear, appearance is more beautiful. Hot dip galvanized coating is thicker, generally 30-60 microns, coating corrosion resistance is higher. Suitable for outdoor work of steel parts, such as highway fences, power towers, large size fasteners and other “rough” workpiece long-term rust prevention.
Of course, the quality of any kind of product is also affected by the implementation of the specification by the manufacturer. If the manufacturer of electric welding mesh has no high implementation specification in the production itself, or the procedure specification has declined in the production line, or there is no higher requirement on the production link. Six: The characteristics of spray blade barbed rope are mechanical strength, adhesion, corrosion resistance, aging resistance, etc., which will greatly increase the service life of the barbed rope, anti-ultraviolet, anti-aging weathering.Pet carrier is generally made of high quality iron wire, low carbon steel wire, stainless steel wire welded, its characteristics are beautiful, lightweight, foldable, easy to store. Pet carrier appearance treatment is generally: cold galvanized, hot galvanized, spray, dip plastic, chrome plating, nickel plating and other methods. Pet cage is mainly used for family pet breeding and protection.
3. Salt water or alkali washing: In order to remove the residual acid in the dissolution tank, it is necessary to carry out salt water or alkali washing treatment on the steel wire to ensure that the surface of the steel wire is clean.
Solder spot, size and wire diameter of galvanized electric welding net. There are clear regulations about size and diameter of silk, as long as it meets the standard, there will not be too much difference. Galvanized welding net production is mainly welding, welding point is firm directly determine the quality of the net. Large galvanized wire purchase process need to carefully observe the solder joint, if the solder joint is too shallow, it shows that the welding is not so strong, it is easy to open welding after use.
(1) The application method of packaging and binding galvanized shaft wire ordering: ① the pulling position on the goods should be reasonably selected. When used to avoid horizontal movement of goods, the pulling position should be as low as possible; When used to avoid overturning the goods, the pulling position can be appropriately high. ② The use of galvanized iron wire [1] pull reinforcement methods mainly include: figure eight, inverted figure eight, cross, zigzag or reverse zigzag and so on. Various pull methods can be used alone, but also two or more than two kinds of use. The pull should be as symmetrical as possible. (3) When pulling reinforcement, the single or double strands of galvanized iron wire will reciprocate around the goods and vehicles between the two tying nodes, and should be pulled tight galvanized iron wire so that the tightness of each strand is as common as possible, and some of the remaining cross around its own rope rod, and the rest of the tail toward the car.
This method is generally the use of hot rolled laminated plate as raw material, the annealed steel plate is first sent to the pickling workshop, with sulfuric acid or hydrochloric acid to remove the surface of the steel sheet oxygen hot galvanizing method. After pickling, the steel plate immediately enters the tank to soak and wait for galvanized, which can prevent the reoxidation of the steel plate. After pickling, water cleaning, squeeze dry, drying, into the zinc pot, the temperature has been maintained at 445-465℃.
Hook fence is made of hook fence for the net surface of the protective net, barrier grid. Material PVC wire, stainless steel wire, good low carbon steel wire, galvanized wire, iron wire hook mesh is made of hook mesh machine for various materials of wire hook knitting, can be divided into two kinds of folding, screwing lock.
Annealing wire is widely used mainly because it has a good elasticity and flexibility, in the annealing process can be a good control of its hardness and softness, it is mainly made of iron wire, more commonly used in the construction industry tie wire use. So why annealing wire according to material properties processing?
The characteristics of these cages are small, light, easy to carry and easy to clean. For small animal cage, the wire diameter of the general iron wire is not very large, the thickness of the plastic is relatively thin, so the use of the time can not be “violence”, otherwise the cage in the “destruction” will occur under the welding or plastic crack.
The distance between the adjacent two thorn rope installation do not know whether you have noticed? Careful observation can find that its spacing is not the same, the thorn rope factory for customer consultation when asking the installation height of the reason.
When this ore is specially refined into metallic iron, carbon, silicon, manganese, and other elements are added to it, so that the refined material is called general pig iron, which is also the material for the initial grade. According to the different requirements of the industry, different weights of alloy ingots are prepared in the smelting furnace according to the standard, such as weaving, Ming, paper, Lang, silicon, etc., and this smelting material is called combined gold ore.
Quality standard: Zinc content per square meter has reached or exceeded 122g.